AC1200 Wi-Fi XPON ONT

Please read this guide before you start with the quick setup upon the first use. This guide instructs how to install and connect the device. For more information such as the description of symbols displayed on relevant materials, please visit www.tendacn.com.

LED indicator	Color	Status	Description
PWR	Green	Solid on	The ONT is powered on properly.
PWR	Green	Off	The ONT is powered off or not powered on properly.
PON	Green	Solid on	The ONT is registered successfully.
		Blinking	The registration is not completed (unregistered or registering).
		Off	The received optical power is lower than the optical receiver sensitivity, or no fiber cord is connected.
LOS	Red	Blinking	The received optical power is lower than the optical receiver sensitivity, or no fiber cord is connected.
LOS	Red	Off	The received optical power is within the optical receiver sensitivity.
LAN	Green	Solid on	There is at least one LAN port connected properly, but no data is being transmitted over the corresponding port.
		Blinking	There is at least one LAN port connected properly, and data is being transmitted over the corresponding port.
		Off	No Ethernet device is connected or the Ethernet device is not connected to any LAN port properly.
2.4G/5G	Green	Solid on	The 2.4 GHz/5 GHz Wi-Fi network is enabled, but no data is being transmitted wirelessly.
		Blinking slowly (0.5s)	The 2.4 GHz/5 GHz Wi-Fi network is enabled, and data is being transmitted wirelessly.
		Blinking quickly (0.25s)	The ONT is performing or pending for WPS negotiation.
		Off	The 2.4 GHz/5 GHz Wi-Fi network is disabled.

Port/Button	Description
PON	Optical fiber port. You can find it on the bottom of the ONT, which is used to connect to a fiber cord.
PWR	Power jack. Please use the included power adapter to connect the ONT to a power source.
LAN1/LAN2	Gigabit LAN ports. Used to connect to a router, switch, computer or IPTV set-top box.
WPS/RST	WPS/Reset button. WPS: Wi-Fi-enabled devices can connect to the Wi-Fi networks of the ONT without entering the password through WPS negotiation. Press the button for 1 to 3 seconds to start the WPS negotiation process of the ONT. The 2.4G and 5G LED indicator blinks quickly. Within 2 minutes, enable the WPS function on a WPS-supported device to establish a WPS connection. Reset: Restore the ONT to the configurations preset by the ISP. After the ONT completes startup, press the button for more than 10 seconds and release it. All LED indicators will light off in a few seconds. When the PWR LED indicator lights solid on again, the ONT is restored to the configurations preset by the ISP.